BS ISO 17987-8:2019
$198.66
Road vehicles. Local Interconnect Network (LIN) – Electrical physical layer (EPL) specification: LIN over DC powerline (DC-LIN)
| Published By | Publication Date | Number of Pages |
| BSI | 2019 | 66 |
This document specifies an additional electrical physical layer (EPL) for the Local Interconnect Network (LIN) of the ISO 17987 series. It specifies the transmission over DC powerline without affecting the LIN higher layers, hereafter named DC-LIN.
The DC-LIN EPL uses a high-frequency modulated carrier to propagate UART bytes (byte-oriented) over the DC powerline.
This document specifies the electrical characteristics, the modulation method of the transmission, and how to impose the carrier signal on the DC powerlines.
The DC-LIN EPL supports bit rates of 9 615 bit/s, 10 417 bit/s, and 19 230 bit/s.
The DC-LIN EPL is applicable for a wide range of DC powerlines including 12-V and 24-V operations, allowing communicating between different DC powerlines via a coupling capacitor. A DC-LIN EPL interface to powerline example is described in Annex A.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 6 | Foreword |
| 7 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms, definitions, symbols, and abbreviated terms |
| 10 | 3.1 Terms and definitions 3.2 Symbols and abbreviated terms |
| 13 | 4 Electrical physical layer requirements 4.1 General |
| 14 | 4.2 Transmitter characteristics 4.2.1 Transmit signal specification |
| 15 | 4.2.2 Byte field modulation scheme |
| 22 | 4.2.3 Break field modulation scheme |
| 23 | 4.2.4 Wake-up signal modulation scheme |
| 26 | 4.3 Timing requirements 4.3.1 Bit rate tolerance |
| 27 | 4.3.2 Bit timing 4.3.3 Bit sample timing 4.3.4 TXD assert timeout event 4.3.5 Delay between transmitted byte field (DC-LIN node A) and received byte field (DC-LIN node A) 4.3.6 Delay between transmitted byte field (DC-LIN node A) and received byte field (DC-LIN node B) |
| 29 | 4.4 Receiver characteristics 4.5 Electrical parameters 4.5.1 General configuration — Coupling to the DC powerline |
| 30 | 4.5.2 Signal specification |
| 31 | 4.5.3 Line-out monitoring |
| 36 | 4.5.4 ESD compliance 4.6 Communication in the presence of faults |
| 38 | Annex A (informative) DC-LIN EPL peripheral interface design considerations |
| 39 | Annex B (normative) DC-LIN EPL conformance test plan |
| 64 | Bibliography |
