BS ISO 16143-3:2014
$142.49
Stainless steels for general purposes – Wire
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 28 |
This part of ISO 16143 specifies requirements for stainless steel wire for common use for which no product standard exists. It includes round, flat, and shaped wire (such as square, hexagonal, or rectangular wire), made of the most commonly used types of stainless steels for general corrosion resistance and high-temperature service. The wire can be supplied in coils or in straightened and cut lengths.
NOTE Steel wire made of corrosion-resistant stainless steel is manufactured from steels mentioned in ISO 16143-2, and steel wire intended for high-temperature purposes is manufactured from steels mentioned in ISO 4955.
In addition to this part of ISO 16143, the general technical delivery requirements of ISO 404 are applicable.
Excluded from this part of ISO 16143 are
-
wire for cold heading,
-
welding wire, and
-
any wire for which a specific product standard exists.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Section sec_1 Section sec_2 1 Scope 2 Normative references |
| 8 | Section sec_3 Section sec_3.1 Section sec_3.2 Section sec_4 Section sec_5 3 Terms and definitions 4 Designation 5 Information to be supplied by the purchaser |
| 9 | Section sec_6 Section sec_6.1 Section sec_6.2 Section sec_6.3 Section sec_6.3.1 6 Manufacturing conditions 6.1 General 6.2 Treatment conditions 6.3 Surface finish |
| 10 | Section sec_6.3.2 Section sec_6.3.3 Section sec_7 Section sec_7.1 Section sec_7.2 Section sec_7.3 Section sec_7.3.1 Section sec_7.3.2 Section sec_7.4 Section sec_7.4.1 Section sec_7.4.2 7 Requirements 7.1 Manufacturing process 7.2 Delivery condition 7.3 Chemical analysis 7.4 Mechanical properties |
| 11 | Section sec_7.5 Section sec_8 Section sec_8.1 Section sec_8.2 Section sec_8.2.1 Section sec_8.2.2 Section sec_8.2.3 7.5 Tolerances on dimensions 8 Inspection, testing, and conformance of products 8.1 General 8.2 Inspection and testing procedures and types of inspection documents |
| 12 | Section sec_8.3 Section sec_8.3.1 Section sec_8.3.2 Section sec_8.4 Section sec_8.4.1 Section sec_8.4.2 Section sec_8.4.3 Section sec_8.5 Section sec_9 Section sec_9.1 Section sec_9.2 Section sec_9.3 8.3 Specific inspection and testing 8.4 Test methods 8.5 Retests 9 Packing and marking |
| 13 | Section sec_9.4 |
| 14 | Table tab_1 |
| 18 | Table tab_2 |
| 19 | Table tab_3 |
| 20 | Table tab_4 Table tab_5 |
| 21 | Table tab_6 |
| 22 | Annex sec_A Table tab_A.1 Annex A (informative) Designations of the steels given in Table 1 and of comparable grades covered in ASTM, EN, JIS, and GB standards |
| 25 | Reference ref_1 Reference ref_2 Bibliography |
