Shopping Cart

No products in the cart.

BS EN ISO 15758:2014

$142.49

Hygrothermal performance of building equipment and industrial installations. Calculation of water vapour diffusion. Cold pipe insulation systems

Published By Publication Date Number of Pages
BSI 2014 26
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This International Standard specifies a method for calculating the density of the water vapour flow rate in cold pipe insulation systems, and the total amount of water diffused into the insulation over time. The calculation method presupposes that water vapour can only migrate into the insulation system by diffusion, with no contribution from airflow. It also assumes the use of homogeneous, isotropic insulation materials so that the water vapour partial pressure is constant at all points equidistant from the axis of the pipe.

This International Standard is applicable when the temperature of the medium in the pipe is above 0 °C. It applies to pipes inside buildings as well as in the open air.

PDF Catalog

PDF Pages PDF Title
4 Foreword
6 Foreword
7 Introduction
9 Section sec_1
Section sec_2
Section sec_3
Section sec_3.1
Section sec_3.2
Section sec_3.3
1 Scope
2 Normative references
3 Terms, definitions and symbols
10 Table tab_1
11 Section sec_4
Section sec_4.1
Section sec_4.2
4 Calculation formulae
4.1 General
4.2 Homogeneous insulation
12 Section sec_4.3
Section sec_4.4
4.3 Multi-layer insulation systems
4.4 Systems with capacity for drying
13 Section sec_5
5 Boundary conditions
14 Section sec_6
Section sec_6.1
Section sec_6.2
Section sec_6.3
6 Calculation procedure
6.1 General
6.2 Calculation of rate of condensation in single homogenous insulation layer
6.3 Calculation of rate of condensation in multi-layer insulation system
16 Table tab_d
Figure fig_1
17 Annex sec_A
Annex sec_A.1
Annex sec_A.2
Annex A
(informative)

Examples

18 Annex sec_A.3
19 Annex sec_B
Annex sec_B.1
Annex B
(informative)

System with capacity for drying and experimental determination of evaporation rate from surface of wet wick fabric

20 Table tab_f
Figure fig_B.1
Annex sec_B.2
Annex sec_B.2.1
Annex sec_B.2.2
21 Annex sec_B.2.3
Annex sec_B.2.4
22 Table tab_h
Figure fig_B.2
23 Reference ref_1
Reference ref_2
Reference ref_3
Reference ref_4
Reference ref_5
Reference ref_6
Reference ref_7
Reference ref_8
Reference ref_9
Reference ref_10
Reference ref_11
Reference ref_12
Reference ref_13
Reference ref_14
Reference ref_15
Bibliography
BS EN ISO 15758:2014
$142.49