BS EN ISO 10724-1:2001:2002 Edition
$102.76
Plastics. Injection moulding of test specimens of thermosetting powder moulding compounds (PMCs) – General principles and moulding of multipurpose test specimens
| Published By | Publication Date | Number of Pages |
| BSI | 2002 | 22 |
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | BRITISH STANDARD |
| 2 | National foreword |
| 4 | EN Foreword |
| 7 | Introduction 1 Scope 2 Normative references |
| 8 | 3 Definitions 3.1 mould temperature 3.2 melt temperature 3.3 melt pressure 3.4 hold pressure 3.5 moulding cycle 3.6 cycle time 3.7 injection time |
| 9 | 3.8 cure time 3.9 hold time 3.10 mould-open time 3.11 cavity 3.12 multi-cavity mould |
| 10 | 3.13 ISO mould 3.14 critical cross-sectional area 3.15 moulding volume 3.16 projected area |
| 12 | 3.17 locking force 3.18 injection velocity 3.19 mass of the moulding 3.20 shot capacity 4 Apparatus 4.1 ISO (multi-cavity) moulds |
| 14 | 4.2 Injection-moulding machine 5 Procedure 5.1 Conditioning of material |
| 15 | 5.2 Injection moulding 5.3 Measurement of mould temperature 5.4 Measurement of the melt temperature 5.5 Post-moulding treatment of test specimens |
| 16 | 6 Report on test-specimen preparation |
| 17 | Annex A (informative) Examples of runner configurations Annex B (informative) Marking the test specimens |
| 18 | Figure B.1 Positions of the cavity numbers Annex C (informative) Example of an injection mould |
| 20 | Annex D (informative) Standardized injection-moulding mould components |
| 21 | Annex ZA (normative) Normative references to international publications with their relevant European publi… |
