ASTM-D3796 2004
$44.96
D3796-90(2004) Standard Practice for Calibration of Type S Pitot Tubes
| Published By | Publication Date | Number of Pages |
| ASTM | 2004 | 13 |
1.1 This practice covers the determination of Type S pitot tube coefficients in the gas velocity range from 305 to 1524 m/min or 5.08 to 25.4 m/s [1000 to 5000 ft/min]. The method applies both to the calibration of isolated Type S pitot tubes (see ), and pitobe assemblies.
1.2 This practice outlines procedures for obtaining Type S pitot tube coefficients by calibration at a single-velocity setting near the midpoint of the normal working range. Type S pitot coefficients obtained by this method will generally be valid to within 3 % over the normal working range. If a more precise correlation between Type S pitot tube coefficient and velocity is desired, multivelocity calibration technique () should be used.
1.3 This practice may be used for the calibration of thermal anemometers for gas velocities in excess of 3 m/s [10 ft/s].
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Document Terminology Summary of Practice Significance and Use Apparatus |
| 2 | Procedure FIG. 1 FIG. 2 |
| 3 | FIG. 3 FIG. 4 |
| 4 | FIG. 5 FIG. 6 |
| 5 | Calculation Precision and Bias FIG. 7 |
| 6 | Keywords FIG. 8 |
| 7 | A1. PROCEDURE FOR MULTIVELOCITY CALIBRATION OF TYPE S PITOT TUBES A1.1 Scope A1.2 Referenced Documents A1.3 Definitions A1.4 Summary of Test Method A1.5 Apparatus A1.6 Procedure FIG. 9 FIG. 10 |
| 8 | A1.7 Calculation A1.8 Precision and Accuracy |
| 9 | FIG. A1.1 |
| 10 | FIG. A1.2 FIG. A1.3 |
| 11 | A2. USE OF CALIBRATED PITOBE ASSEMBLIES TO MEASURE VELOCITY IN SMALL DUCTS A2.1 FIG. A2.1 |
| 12 | REFERENCES FIG. A2.2 |
